Side Access Panel - HP Compaq SP700 User Manual

Side Access Panel

To remove the side access panel:
1. Perform the service preparations shown on page 3-2.
2. Loosen the four rear panel thumbscrews, then slide the access panel off.
Figure 3-4. Loosening the thumbscrews and removing the side access panel
IMPORTANT: When replacing the side access panel, be sure to tighten all four
thumbscrews.
NOTE: The hood label attached to the inside of the side access panel provides system
configurations and the installation of additional components.
To replace the side access panel:
1. Be sure all grounding clips and EMI gaskets (shielding strips) are in place.
2. Slide the side access panel in at an angle on one side, drop it into place, then slide it into
the unit completely.
3. Tighten the rear panel thumbscrews.
CAUTION: Do not operate the workstation with the side access panel removed.
The panel is an integral part of the cooling system; removing it while the system is
running may adversely affect data integrity.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching.
Compaq Professional Workstation SP700 Maintenance and Service Guide
3-5