Expansion Boards - HP Compaq SP700 User Manual

3-12 Removal and Replacement Procedures

Expansion Boards

This section discusses removal and replacement procedures for PCI or ISA expansion boards.
NOTE: The following instructions also apply to installing and removing graphics controllers. For
information about the installed graphics controller, refer to the appropriate guide on the
SmartStart for Workstations CD under X:\DOCS\GRAPHICS, where X is the CD-ROM drive
designation.
Identifying PCI and ISA Expansion Slots
The Compaq Professional Workstation SP700 contains eight expansion slots on the backplane
board (also called riser card): five PCI expansion slots, one shared PCI/ISA shared expansion
slot, and two ISA expansion slots. The following illustration identifies the physical locations.
Refer to the corresponding table for component names.
Figure 3-10. Overview of expansion slots
1
2
3
4
5
6
7
8