Installing the Battery
To install the external real-time clock battery:
CAUTION: Static electricity can damage the electronic components of the
workstation. Before beginning these procedures, be sure you are properly
grounded. See "Electrostatic Discharge" in Chapter 2 for more information.
1.
Perform the service preparations shown on page 3-2.
2.
Remove the following components:
workstation feet
side access panel
I/O bracket assembly
3.
Place the workstation on its side.
4.
Remove and discard the protective covering on the adhesive on the hook and loop
fastener on the back of the battery and attach the battery to the side of the power supply.
5.
Plug the battery connector onto pins 1-4 on the battery header of the system board.
Figure 3-42.
Attaching the replacement battery
Compaq Professional Workstation SP700 Maintenance and Service Guide
3-51