3-52
Removal and Replacement Procedures
Change the jumper from pins 6-7 1 to pins 5-6 2.
6.
Figure 3-43. Changing the jumper from pins 6-7 to pins 5-6
7.
Place the pale blue sticker included with the battery kit above the power connector on the
back of the workstation.
8.
Reverse steps 1 and 2 to reassemble the workstation, then turn on the workstation.
9.
Run Computer Setup to reconfigure the system.
10. If the workstation has a Compaq hard drive, you have now successfully completed the
installation.
If the workstation has a third-party hard drive, you must reconfigure the hard drive using the
parameters you recorded before you began the installation procedure.
1
2