To install a new system board with tray and cage:
1.
Remove the following components from the system board with tray and cage:
DIMMs
secondary processor or terminator board
secondary processor power modules (if installed)
AGP graphics controller (if installed)
external battery (if installed)
2.
Install the components on the new system board tray. Before reinstalling the DIMMs, see
"Important Guidelines for DIMM Installation" later in this chapter.
3.
Slide the new system board tray into the chassis.
4.
Connect all cables to the system board.
5.
Replace the I/O bracket assembly and the side access panel.
IMPORTANT: Before replacing the I/O bracket assembly, read "Important Guidelines for I/O
Bracket Assembly Replacement" earlier in this chapter.
Compaq Professional Workstation SP700 Maintenance and Service Guide
3-41