CR Reader, CR Advanced Reader, CR Multiformat Reader | Getting started | 53
Before Switching Off
Check that the digitizer is not scanning an image plate. If the digitizer is
scanning an image plate, the status indicator is blinking yellow.
Switching Off
It is recommended to switch off the digitizer at the end of the day.
To switch off, press the power button.
Power button
1.
Note: A clamped cassette should be removed before switching off
the device.
1
Note: After switch off, the device is still in stand-by mode. To
remove the device from the mains supply disconnect the mains
plug.
Note: The optical components of the digitizer are switched off
automatically after not been used for 3 hours. Restarting the
digitizer takes approximately 3 minutes. During this time
emergency digitizing is not possible!
2591D EN 20191028 1712