Starting Dx-D 100 - AGFA DX-D 100 User Manual

Starting DX-D 100

To start DX-D 100:
1. Unplug the unit from the mains power.
2. Unlock the device.
• To unlock the device using the key, switch the key on the control panel
to the "ON" position.
"ON" position
1.
• To unlock the device using the on/off keypad, press and hold the
power button until the green status indicator light starts blinking, dial
the four digit access code and press the enter button.
Power button
1.
Enter button
2.
The X-ray generator is powered on.
The Windows log in window appears.
3. Log in to Windows.
• To log in using your password, enter your user name and password and
click OK.
• To log in using the optional RFID reader, select the Aloaha login
method, touch the RFID reader with your personal RFID key and click
OK.
The NX application and the software console become available on the
control console.
For detailed information about starting up NX, refer to the NX User
Manual, document 4420.
4. On the control panel, check the battery levels.
If the red indicator is blinking, operation is not allowed. In that case, it is
necessary to charge the batteries.
1
1
2
DX-D 100 | Getting started | 49
0187K EN 20191024 1609