Starting The Digitizer - AGFA DX-G User Manual

58 | DX-G, DX-M | Getting started

Starting the Digitizer

Procedure:
1. Make sure the digitizer is connected to a workstation and that the
workstation is running the appropriate NX Software.
2. Make sure that the power plug is plugged into the socket.
3. Remove cassettes from the input buffer and input slot of the digitizer.
4. Press the main switch.
• Main switch
The Start Up screen is visible on the Touch panel:
The digitizer starts the following operation sequence:
2321G EN 20181126 1428
1