Table of Contents
Advertisement
This chapter describes the front panel and rear panel of the Switch and shows you how to make the
hardware connections.
3.1 Front Panel
The following figures show the front panels of the Switch.
Figure 10 Front Panel: XS1930-10
Figure 11 Front Panel: XS1930-12HP
The following table describes the ports.
Table 4 Front Panel Connections
CONNECTOR
2 or 8 100 Mbps, 1
Gbps, 2.5 Gbps, 5
Gbps, and 10 Gbps
RJ-45 Ethernet Ports
8 100 Mbps, 1 Gbps,
2.5 Gbps, 5 Gbps,
and 10 Gbps RJ-45
PoE Ports
2 10 GbE SFP+ Slots
Reset
Restore
Hardware Panels
DESCRIPTION
These are 10GBase-T auto-negotiating and auto-crossover Ethernet ports.
Connect these ports to a computer, a hub, a router, or an Ethernet switch.
These are 10GBase-T auto-negotiating and auto-crossover Ethernet ports.
Connect these ports to a computer, a hub, a router, or an Ethernet switch.
Use SFP+ transceivers in these ports for high-bandwidth backbone connections. You can
also insert an SFP+ Direct Attach Copper (DAC) in the SFP+ slot.
Press the RESET button to reboot the Switch without turning the power off. See
page 35
for more information about the LED behavior.
Press the RESTORE button for three to six seconds to have the Switch automatically reboot
and restore the last-saved custom default file. See
information about the LED behavior.
Press the RESTORE button for more than seven seconds to have the Switch automatically
reboot and restore the factory default file. See
about the LED behavior.
XS1930 Series User's Guide
31
C
H A P T E R
Section 3.3 on page 35
Section 3.3 on page 35
3
Section 3.3 on
for more
for more information
Advertisement
Table of Contents
Troubleshooting
