Setting Port Vid - ZyXEL Communications GS1920v2 Series User Manual

In the
2 Sta tic VL AN
descriptive name in the
VL AN G ro up ID
Note: The
VL AN G ro up ID
same VLAN ID.
Since the
3
VL AN2
permanent member of the VLAN only.
To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames properly, clear
4
the
T X T a g g ing
Click to save the settings to the run-time memory. Settings in the run-time memory are lost when the
5
Add
Switch's power is turned off.
5.1.2 Se tting Po rt VID
Use PVID to add a tag to incoming untagged frames received on that port so that the frames are
forwarded to the VLAN group that the tag defines.
In the example network, configure 2 as the port VID on port 1 so that any untagged frames received on
that port get sent to VLAN 2.
Chapter 5 Initial Setup Example
screen, select , enter a
AC T IVE
field and enter 2 in the
Na m e
field for the network.
VL AN2
field in this screen and the
network is connected to port 1 on the Switch, select
check box to set the Switch to remove VLAN tags before sending.
GS1920v2 Series User's Guide
field in the
VID
57
screen refer to the
IP Se tup
to configure port 1 to be a
Fixe d