Technical Reference - ZyXEL Communications XS1930-12HP User Manual

Figure 220 Management > Access Control > Remote Management
The following table describes the labels in this screen.
Table 158 Management > Access Control > Remote Management
LABEL
Entry
Active
Start Address
End Address
Telnet/FTP/
HTTP/ICMP/
SNMP/SSH/
HTTPS
Apply
Cancel

36.7 Technical Reference

This section provides technical background information on the topics discussed in this chapter.
Chapter 36 Access Control
DESCRIPTION
This is the client set index number. A "client set" is a group of one or more "trusted computers"
from which an administrator may use a service to manage the Switch.
Select this check box to activate this secured client set. Clear the check box if you wish to
temporarily disable the set without deleting it.
Configure the IP address range of trusted computers from which you can manage this Switch.
The Switch checks if the client IP address of a computer requesting a service or protocol matches
the range set here. The Switch immediately disconnects the session if it does not match.
Select services that may be used for managing the Switch from the specified trusted computers.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XS1930 Series User's Guide
302