Org-Specific Tlv Setting - ZyXEL Communications XS1930-12HP User Manual

Table 125 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
LABEL
System Capabilities
System Description
System Name
Apply
Cancel

31.6.2 Org-specific TLV Setting

Use this screen to configure organization-specific TLV settings. Click Advanced Application > LLDP > LLDP
Configuration (Click Here) > Org-specific TLV Setting to display the screen as shown next.
Figure 178 Advanced Application > LLDP > LLDP Configuration> Org-specific TLV Setting
The following table describes the labels in this screen.
Table 126 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
LABEL
Port
*
Dot1 TLV
Port VLAN ID
Dot3 TLV
Link
Aggregation
Chapter 31 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
Select the check box(es) to enable or to disable the sending of System Capabilities TLVs on
the port(s).
Select the check box(es) to enable or to disable the sending of System Description TLVs on
the port(s).
Select the check box(es) to enable or to disable the sending of System Name TLVs on the
port(s).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
This displays the Switch's port number. * means all ports.
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Select the check box(es) to enable or disable the sending of IEEE 802.1 Port VLAN ID TLVs on
the port(s). All check boxes in this column are enabled by default.
Select the check box(es) to enable or disable the sending of IEEE 802.3 Link Aggregation TLVs
on the port(s).
XS1930 Series User's Guide
251