Table of Contents
Advertisement
This chapter introduces the port status screens.
48.1 Port Status
This screen displays a port statistical summary with links to each port showing statistical details. To view
the port statistics, click Status in all web configurator screens and then the Port Status link in the Quick
Links section of the Status screen to display the Port Status screen as shown next. You can also click
Management > Port Status to see the following screen.
Figure 252 Port Status (for PoE model(s))
The following table describes the labels in this screen.
Table 180 Port Status
LABEL
Port
Name
Link
State
DESCRIPTION
This identifies the Ethernet port. Click a port number to display the Port Details screen (refer to
Figure 253 on page
343).
This is the name you assigned to this port in the Basic Setting > Port Setup screen.
This field displays the speed (either 100M for 100Mbps, 1G for 1 Gbps, 2.5G for 2.5 Gbps, 5G for 5
Gbps, or 10G for 10 Gbps) and the duplex (F for full duplex or H for half). This field displays Down if
the port is not connected to any device.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port. See
138
for more information.
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it displays STOP.
When LACP (Link Aggregation Control Protocol), STP, and dot1x are in blocking state, it displays
Blocking.
XS1930 Series User's Guide
C
H A P T E R
Port Status
341
48
page
Advertisement
Table of Contents
Troubleshooting
