This chapter describes the front panel and rear panel of the Switch and shows you how to make the
hardware connections.
3.1 Front Panel Connections
The following figures show the front panels of the Switch.
Figure 11 Front Panel: XMG1930-30
Figure 12 Front Panel: XMG1930-30HP
The following table describes the ports.
Table 6 Front Panel Connections
CONNECTOR
100M, 1G, and 2.5G
RJ-45 Ethernet Ports
Port 1 – 24
100M, 1G, 2.5G, 5G,
and 10G RJ-45
Ethernet Ports
Port 25 – 28
100M, 1G, and 2.5G
RJ-45 PoE Ports
Port 1 – 20
100M, 1G, and 2.5G
RJ-45 PoE Ports
Port 21 – 24
Chapter 3 Hardware Panels
Hardware Panels
DESCRIPTION
These are 2.5GBase-T auto-negotiating and auto-crossover Ethernet ports.
Connect these ports to a notebook computer, a workstation, a WiFi 6 (802.11ax) router, a
WiFi 6 (802.11ax) AP (Access Point), or an Ethernet switch.
These are 10GBase-T auto-negotiating and auto-crossover Ethernet ports.
Connect these ports to a gaming computer, a NAS (network-attached storage), or a server.
These are 2.5GBase-T auto-negotiating and auto-crossover Ethernet port, with support for
IEEE802.3at PoE+ 30 W ports.
Connect these ports to a PTZ (pan, tilt and zoom) camera, a WiFi 6 (802.11ax) router, a WiFi 6
(802.11ax) AP, or an Ethernet switch.
These are 2.5GBase-T auto-negotiating and auto-crossover Ethernet port, with support for
IEEE802.3bt PoE++ 60 W ports.
Connect these ports to a PTZ (pan, tilt and zoom) camera, a WiFi 6 (802.11ax) router, a WiFi 6
(802.11ax) AP, or an Ethernet switch.
XMG1930 Series User's Guide
34
C
H A P T E R
3