Table of Contents
Advertisement
Edit Setup Mode
The Zone-specific Parameters
Aux Send Level
The Aux Send Level parameter determines the send level for the auxiliary effects of the
currently selected Zone. You can select any level from 0 to 127. Pressing both Value buttons
simultaneously will set this parameter to 20.
For a description of the auxiliary effects of a Setup, see About Auxiliary Effects on page 8-14 and
Common Parameters on page 8-14.
Transpose
The Transpose parameter determines the transposition for the currently selected Zone. You
can set this to any value from -128 semitones to 127 semitones. Pressing both Value buttons
simultaneously will set this parameter to 0.
Entry Pan
The Entry Pan parameter determines the Pan MIDI message that the currently selected
Zone sends when the Setup is loaded. You can set this parameter to any pan setting from 0
(full left pan) to 127 (full right pan). For zero panning, select 64 for this parameter. Pressing
both Value buttons simultaneously will set this parameter to 64.
Entry Volume
The Entry Volume parameter determines the Volume MIDI message that the currently
selected Zone sends when the Setup is loaded. You can set this parameter to any volume
setting from 0 to 127. Pressing both Value buttons simultaneously will set this parameter to
127.
Low Velocity
The Low Velocity parameter determines the lowest velocity that a keystroke must have
in order to trigger a note in the currently selected Zone. You can set this parameter to
any velocity between 1 and 127. Pressing both Value buttons simultaneously will set this
parameter to 1.
If, for example, you set Low Velocity to 20, then only keystrokes with velocities of 20 or
above will trigger a note. Keystrokes with velocities lower than 20 will not trigger a note.
8-8
Advertisement
Table of Contents
