Advertisement
Wiring
Blue 2-Pin Connector
Valet Switch
Select a mounting location for the switch that is easily accessible to the driver of the vehicle. The
switch does not have to be concealed, however, concealing the switch is always recommended,
as this provides an even high level of security to the vehicle. Mount the valet switch in a hidden but accessible
location. Route the valet switch wires to the control module.
Black 9-Pin Mini
Connector
White/Black Wire:
(Negative Safety Shut
Down Input.)
The White/Black wire
provides an instant shutdown for the
remote start, whenever it is
grounded. Connect the wire to the
hood pin switch previously installed.
this wire must be routed through a
grommet in the firewall and
connected to the hood pin switch. If the pin switch is to be used with an alarm system, connect this wire with
diode. Diodes are required when the hood pin is used as a triggering device. Wire as shown.
White/Violet Wire:
This wire provides an instant shutdown for the remote start, whenever it gets +12 volts. If the brake lights switch
in the vehicle switches +12 Volts to the brake light circuit, connect this wire to the output side of the brake switch.
This will allow the remote start
to shut down if an attempt is
made to operate the vehicle
without the key while running
under the control of the remote
start. In most vehicles, in order
to shift gear, the brake pedal
must be depressed. The brake
input will in turn cause the
remote start unit to shut off.
Black/White Wire:
When the Black/white wire is grounded, the remote start unit is operable. When this wire is open from ground, the
remote start is disabled.
1. An optional "remote start toggle switch" can be added on to temporarily disable the Remote Start Device, it can
prevent the vehicle from being remote started accidentally. This feature is useful if the vehicle is being serviced
or stored in an enclosed area. To disable the remote start, move the optional remote start enable toggle switch
to the OFF position. To enable the remote start, move the optional remote start enable toggle switch to the ON
position.
2. If needed, this wire can connect to the Park/Neutral switch in the vehicle (See testing in your installation guide).
Important Note: Directly connect the Black/White wire to the "Ground" when this wire is
not used for it's intended safety purpose or remote start will not operate.
6
Positive Safety Shut Down Input
Switch Closes when
Brake is Depressed
Brake Pedal
(-) Remote Start Enable Toggle Switch Input, (-) Neutral Safety Switch Input
White/Black Wire
Negative Safety
Diode
+12 Volts
To Lights
Hood Pin Switch
To Alarm Instant
Trigger Blue Wire
Diode
H
White/Violet Wire
9-Pin Mini
Connector
Brake Light Bulbs
Black
Advertisement
