Advertisement
Quick Links
M2 Owner's & Installation Manual
Wiring Diagrams
2-Pin White
Positive 3-Wire Door Lock System
Blue Wire
Door Lock
Green Wire
Door Unlock
10-PIN Connection
For technical assistance, please call (800) 638-3600,
or visit www.magnadyne.com
10-Pin White
3-Pin Black
10-Pin Connector
For Connection Instructions
See Diagram Below
Master
Locking
Switch
To Existing Lock Relay
+ 12V
To Existing Unlock Relay
White Wire: Parking Light Output
Red Wire: +12V To Fuse Box (Battery)
Brown Wire:
Black Wire: To Chassis Ground
Orange Wire: 500mA Grounded When Armed (Optional Relay Needed)
Gray Wire: (-) Channel 2 Output (Optional Relay Needed)
Green Wire: (-) Channel 3 Output (Optional Relay Needed)
Blue Wire: Do Not Connect. Please Tape Off
Violet Wire: (-) Dome Light Output (Optional Relay Needed)
Yellow Wire: To Ignition Key (Switched +12V)
Black Wire: Antenna (Do Not Ground)
2-Pin Blue
Valet Switch
Blue Wire: Door Lock (See Diagram Below)
Green Wire: Door Lock (See Diagram Below)
LED (Optional)
Negative 3-Wire Door Lock System
Blue Wire
Door Unlock
Green Wire
Door lock
10A
15A
(-) Output To Horn Relay
Master
Locking
Switch
To Existing Unlock Relay
Ground
To Existing Lock Relay
Vehicle Parking
Lights
Vehicle Horn
Advertisement
Related Manuals for Marksman M2
Summary of Contents for Marksman M2
- Page 1 M2 Owner’s & Installation Manual For technical assistance, please call (800) 638-3600, or visit www.magnadyne.com Wiring Diagrams Black Wire: Antenna (Do Not Ground) 10-Pin White 2-Pin Blue 3-Pin Black 2-Pin White 10-Pin Connector For Connection Instructions Valet Switch See Diagram Below...
- Page 2 B. PROGRAMMING SYSTEMS FEATURES hear one long chirp and one short chirp for the Designated The M2 has 6 features that are programmable. To program these Channel, or two long chirps and one short chirp for the Auto features, repeat the following procedures.
- Page 3 also flash the same number of times the valet switch was position to get the feature programmed correctly. pressed to confirm the selection. 4. When you are finished setting all the programmable features, you can do nothing for 15 seconds and the system will exit the Note 2: Feature selection is sequential.
- Page 4 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation. M2-0MIM © Copyright 2003 Rev. C 4-4-03 Magnadyne Corporation...