Advertisement
Alarm Feature Programming (Part 1)
Use the transmitter buttons as illustrated to adjust the features required. Keep re-pressing the transmitter button
that relates to the feature you want to adjust until the correct amount of chirps/beeps is heard. Move on to the
next feature.
One Chirp
Button
LED One Pulse
(Factory Default Setting)
All Chirps
Active Arming
Automatic Rearm On
Instant Door Ajar Warning
+
3 Hours Time Start
+
Inactive Car-Jack Mode
+
Panic with Ignition Off
Alarm Feature Programming (Part 2)
O FF
Turn the ignition switch from the OFF position to the
ON position three (3) times leaving it in the OFF
position the third time.
Remote Feature Programming
Two Chirps
LED Two Pulses
Siren Only
Passive Arming without
Passive Door Locking
Automatic Rearm Off
Door Ajar Error Chirp with 45
Second Check delay
2 Hours Time Start
Active Car-Jack Mode
Panic with Ignition On & Off
Step 4
ON
Step 1
ON
Step 3
Three Chirps
LED Three Pulses
Passive Arming with
Passive Door Locking
Passive Car
Panic with Ignition On & Off
Panic with No Time Limit
Turn On the Ignition
3 long chirps & 3 flashes of the parking lights will
confirm exit of the programming mode.
Note: Waiting 15 seconds after the last command will
also cause the system to automatically exit the
programming mode.
3X
Before 15 seconds has passed, push and release the
valet switch three (3) times then push the valet switch a
fourth time and hold it down until two (2) short
chirps/beeps + one (1) long chirp/beep is heard then
release it. You are now in Part 2 programming mode.
LED Four Pulses
Horn Only
Jack Mode
Without Panic Function
Step 2
3X + 1X (Hold)
Four Chirps
All Chirps Off
17
Advertisement
