Advertisement
Programming the Transmitter
Programming the Remote Transmitter
(Includes the Standard Type and LCD Transmitter Type)
Note: This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory is
exceeded, the security system will start deleting transmitters from memory in chronological order.
OFF
Turn the ignition switch from the OFF position to the
ON position 3 times leaving it in the ON position the
third time.
Step 3
4
5
C
4/5/6
Press the "Lock" button on the first
transmitter until you hear a confirmation
chirp/beep. The transmitter is now
coded into the system.
Alarm Feature Programming (Part 1)
Examine the 3 different feature charts enclosed and decide which feature will get changed. Circling the feature to
be changed will make the programming process much easier to perform.
O FF
Turn the ignition switch from the OFF position to the
ON position 3 times leaving it in the OFF position the
third time.
16
Step 1
ON
4
Repeat for each additional
transmitter.
Step 1
ON
3X
3X
Before 15 seconds has passed, push and release the valet
switch 2 times then push the valet switch a third time and
hold it in on until a long chirp or beep is heard, then
release it. You are now in transmitter programming mode.
Step 4
5
C
4/5/6
Before 15 seconds has passed, push and release the
valet switch 1 time then push the valet switch a second
time and hold it in on until 1 short and 1 long chirp or
beep is heard, then release it. You are now in Alarm
Feature Programming Part 1 programming mode
Step 2
2X + 1X (Hold)
Step 5
O FF
When finished, either turn off the
ignition key or wait for 15 seconds to
get out of transmitter programming
mode. You will hear 3 long
chirps/beeps to indicate you are out of
the transmitter programming mode.
Step 2
1X + 1X (Hold)
Advertisement
