Advertisement
Wiring
White 6-Pin Heavy Gauge Wiring Connector
Pink Wire:
(Ignition 2 Output)
Some vehicles have (2) ignition wires that must be powered. Connect the "Pink" wire to the ignition 2 wire
from the ignition switch. No connection required on vehicles without a second ignition.
Brown Wire:
(Accessory Output, Heater/ACC Output)
Connect the "Brown" wire to the accessory wire that powers the climate control system. An accessory wire
will show +12 volts when the ignition switch is turned to the "ACCESSORY" or "ON" and "RUN" positions, it
will show 0 Volts when the key is turned to the "OFF" and "START" or "CRANK" position. There will often be
more than one accessory wire in the ignition harness. The correct accessory wire will power the vehicle's
climate control system . Some vehicles may have separate wires for the blower motor and the air conditioning
compressor. In such cases, it will be necessary to add a relay to power the second accessory wire.
White 5-Pin Connector
Red Wire with White Stripe:
The "Red/White" wire has already been assembled to work with a +12 volt switched parking
light system (most vehicles). For vehicles with ground switched parking light activation cut
this wire and connect it to ground.
White Wire:
(Parking Light Relay Output, +12 V 10A Output + or - selectable)
Connect the "White" wire to the parking light wire coming from the headlight switch. Do not connect the
"White" wire to the dashboard lighting dimmer switch (damage to the dimmer will result). The limitation of
the "White" wire is 10 Amp max. Do not exceed this limit or damage to the alarm and parking relay will result.
Black Wire:
(System Ground)
This is main ground connection of the alarm module. Make this connection to a solid section of the vehicle
frame. Do not connect this wire to any existing ground wires supplied by the factory wire loom, make the
connection to the vehicle's frame directly.
Brown Wire:
(Programmable Siren Drive Output - Factory Default Setting)
This is the positive (+) output
connection for the siren, current
capacity is 2 Amps. Make connection
to the (+) red wire from the siren.
Make the (-) black wire coming from
the siren to a good chassis ground.
(+) Low Current Horn Output
(Set Alarm Feature Programming
Part 2 to Horn Output - Optional
Setting)
This wire is provided to use the
existing vehicle's horn as the alarm
system's optional warning audible
device. It's a transistorized low current output, and should only be connected to the low current positive (+)
output from the vehicle's horn switch.
Red Wire:
(System Power +12V Constant)
The "Red" wire supplies power to the system. Connect this wire to a constant +12 volt source.
4
(continued)
(Parking Light Relay Input)
Brown
Wire
5-Pin
87
White Plug
87a
86
Fuse
To Horn
To Ground
85
+12V or Ground Depending
30
on System Requirements
Advertisement
