Advertisement
Remote Start Operation and Feature Programming (Stage 2)
Stage 2: Remote Start Operation Programming
In this mode you will program the type of engine starting detection you want to use in your installation. There are
3 types available:
1. Tachometer (RPM) Detection: (Most reliable and recommended) This type of detection requires
a hard wire connection to the vehicles ignition coil.
2. Voltage Detection: This method detects the drop and rise in the battery voltage when the vehicle is started by
remote. This type of detection requires a solid main power input connection but it does not require any
additional hard wire connections.
3. Elapsed Timer: This method is the easiest for installation but is not always the best method for year round
usage (Summer and Winter). To operate this method, you will program a specific time window for the remote
start unit to crank the engine. Battery strength, environment and the aging process of the vehicle may require
the timer to re-set from time to time or season to season.
Entering Stage 2 Remote Start Operation Programming
OFF
Turn the ignition switch from the OFF position to the
ON position three (3) times leaving it in the OFF
position the third time.
Use the transmitter buttons as illustrated to adjust the features required. Keep re-pressing the transmitter button that
relates to the feature you want to adjust until the correct amount of chirps/beeps is heard. Move on to the next feature.
One Chirp
Button
LED One Pulse
(Factory Default Setting)
Exit the programming mode (3 long chirps and 3 parking light flashes to confirm exit)
Tachometer
+
Checking Type
RPM Learning
Start Timer:
0.6 second
Low Check Level
(Default for
Tach Check Type)
-
Start or Stop the System for Testing & Adjusting
"TEST" Mode for Zone 2
+
Instant Trigger & Zone 3
Door Trigger
22
Step 1
ON
3X
Remote Start Feature Programming
Two Chirps
LED Two Pulses
Voltage Checking
0.8 second (2 chirps)
1.4 second (5 chirps)
2.0 second (8 chirps)
Hi Check Level
(Default for
Voltage Check Type)
"TEST" Mode for
Zone 1 & Zone 4
(2 Stage Shock Sensor)
Before 15 seconds has passed, push and release the valet
switch nine (9) times then push the valet switch a tenth
time and hold it down until five (5) short chirps/beeps +
one (1) long chirp/beep is heard then release it. You are
now in Stage 2 Remote Start Feature Programming Mode.
Step 3
Three Chirps
LED Three Pulses
Type
Crank Type
1.0 second (3 chirps)
1.6 second (6 chirps)
3.0 second (9 chirps)
Step 2
9X + 1X (Hold)
Four Chirps
LED Four Pulses
Fixed
1.2 second (4 chirps)
1.8 second (7 chirps)
4.0 second (10 chirps)
Advertisement
