Advertisement
Alarm Feature Programming (Part 3)
Channel 4/5/6 Timer Control Output Programming:
1. Turn the ignition switch "On/Off" three times, stay in the "Off" position.
2. Push the valet switch six times and hold it until three chirps with a long chirp is heard, then release the valet
switch. You are now in Alarm Feature 3 Programming Mode.
Timer Program:
1a. Press and release the transmitter buttons
indicates you are in Feature Channel 4 Timer Programming Mode.
1b. Press and release the transmitter buttons
indicates you are in Feature Channel 5 Timer Programming Mode.
1c. Press and release the transmitter buttons
indicates you are in Feature Channel 6 Timer Programming Mode.
2. Press and hold the valet switch, the timer will immediately start.
3. When the desired interval has passed, release the valet switch, 1 long chirp will confirm timer feature.
(Set to any interval between 1 second and 2 minutes)
Note:
Momentary Output: The momentary output selection will output a negative signal from the Channel 4/5/6 output
immediately when the Channel 4/5/6 button is pressed and will continue until the button is released.
Latched Output: The latched output selection will output a negative signal as soon as the channel 4/5/6 button is
pressed and will continue until the button is pressed again.
Latched Output/Reset with Ignition: The latched/reset with ignition output selection operation just like the latched
output but will reset or stop when the ignition is turned on.
Key Sensor Bypass Output: The 20 second setting is for a key sensor wire bypass that some Chrysler and Toyota
vehicles need to activate remote start. The wire comes "ON" when the start mode is activated and stays on for 20
seconds (Channel 4 output only).
Remote Start Operation and Feature Programming (Stage 1)
Examine the 2 feature charts enclosed and decide which features will get changed. Circling the feature to be
changed will make the programming process much easier to perform.
Stage 1: Remote Start Operation Programming
OF F
Turn the ignition switch from the OFF position to the
ON position three (3) times leaving it in the OFF
position the third time.
20
Step 1
ON
+
for four times. (4) LED flashes, (4) siren/horn chirp
+
for four times. (4) LED flashes, (4) siren/horn chirp
+
for four times. (4) LED flashes, (4) siren/horn chirp
3X
Before 15 seconds has passed, push and release the
valet switch seven (7) times then push the valet switch
a eighth time and hold it down until four (4) short
chirps/beeps + one (1) long chirp/beep is heard then
release it. You are now in Stage 1 Remote Start
Feature Programming Mode.
Step 2
7X + 1X (Hold)
Advertisement
