Advertisement
Shutdown Diagnostics
The unit has the ability to report the cause of the last shutdown of the remote start system.
1. Turn the Ignition switch to "On" position.
2. Press the (
) button on the transmitter
3. The LED will now report the last system shutdown by flashing for 3 cycles in the following grouped patterns:
LED
Shutdown Mode
Flashes
1
(-) Safety Shutdown Input (Hood)
(+) Safety Shutdown Input (Brake)
2
or Neutral Safety Switch Input
Fail
3
No RPM or Low Voltage
Check White/Red Wire Connection
5
Over-Rev
6
System Timed Out
7
Transmitter
8
Tach Signal has not Been Learned
Test Mode
In this test mode, this system can test the Zone2/Instant Ground Trigger, the Zone3/Door Trigger, and the
Zone1-4/Optional Sensor Sensitivity. The installer can save time to test the optional sensor sensitivity and sensor
without using the traditional arming/disarming procedures to test the sensors.
Step 1
OF F
Turn the ignition switch from the
OFF position to the ON position
three (3) times leaving it in the Off
position the third time.
Step 4
4
5
C
4/5/6
1. Close the Hood
2. Check White/Black Wire Connection (Black 9-Pin Mini)
1. Check White/Violet Wire Connection (Black 9-Pin Mini )
2. Move the Enable Toggle Switch to "On" position
3. Move the gear selector to "Park"/ "Neutral" Position.
4. Check Black/White Wire Connection (Black 9-Pin Mini)
Tachometer Checking Type:
Voltage Checking Type:
Program the "Check Level" from "Hi Check Level" to
"Low Check Level"
Check Tach Signal Feature Programming
ON
3X
Before 15 seconds has passed, push
and release the valet switch nine (9)
times then push the valet switch a
tenth time and hold it down until five
(5) chirps/beeps and a long chirp then
release it. You are now in "Test Mode".
Press the (
+
again. 2 chirp and 2 parking light flash
will confirm you are now in Zone 4
6
Bi
Optional Sensor Test Mode.
1. Activate the warn away: Short Chirp.
SET
2. Activate Full Alarm: Long Chirp.
3. Continue to test the sensor until
you reach the proper setting.
(If Installed)
Step 2
9X + 1X (Hold)
) button once
Step 3
4
5
C
4/5/6
Press the ( ) (
) button once at the
same time. 1 LED flash 1 siren/horn
chirp to indicate you are now in
Zone 2/instant ground trigger.
Trigger Sensor Flashes
Zone 2: Instant Ground
Trigger (Blue Wire)
Zone 3: Door Trigger
(Green or Violet Wire)
6
Bi
SET
Chirps
2
3
27
Advertisement
