Advertisement
Remote Start Operation and Feature Programming
Tachometer Detection Programming
If you have previously selected tachometer detection, you are required to program 2 additional features as enclosed.
Feature 1: RPM Learning
Step 1
OF F
Turn the ignition switch from the
OFF position to the ON position
three (3) times leaving it in the Off
position the third time.
Step 4
4
5
C
4/5/6
Press unlock button before
you turn on the ignition
key.
Press the ( ) button twice on the transmitter to start the
vehicle. If everything is correct, the engine will crank and fire
without over-running or under-running the starter. If all things
seem correct, press the (
running. If a cranking problem is noticed, move to Step 9 to
adjust the crank detection feature otherwise follow Step 8 and
get out of the programming mode.
ON
3X
Before 15 seconds has passed,
push and release the valet switch
nine (9) times then push the valet
switch a tenth time and hold it down
until five (5) short chirps/beeps +
one (1) long chirp/beep is heard
then release it.
Step 5
ON
START
Start the vehicle's engine
with the ignition key (while
the engine is running the
parking lights and the LED
should be flashing. If they
are not you need to re-
check your tachometer
wire connection).
Step 8
6
Bi
SET
) twice to stop the engine from
Step 2
9X + 1X (Hold)
Step 6
Press and hold the valet
switch. When the RPM
level is learned, you will
hear a long chirp/beep and
the LED will be on steady
for 2 seconds.
Press the (Lock) button on the transmitter to get
out of the programming mode. You will hear 3
long chirps and get 3 parking light flashes for
confirmation.
Step 3
4
C
4/5/6
Press and release the (
button once. The LED will flash once
and you will hear 1 chirp/beep to
indicate that you are in RPM Feature
learning mode.
Step 7
O F F
Turn OFF the ignition to
stop the engine.
Remember, you are still in
programming mode.
Step 9
4
5
C
4/5/6
5
+
)
23
Advertisement
