Advertisement
Wiring
White 2-Pin Connector
LED Status Indicator:
The LED indicator status should be mounted in a highly visible area such as top of the dashboard, on top of
the shifter console or on dashboard face. Leave at least 6mm space behind the mounting location for LED
housing. Once a suitable location is chosen, drill a 1/4" hole. Run the LED wires though the hole then press
the 2-Pin LED housing into the place. Route the LED wires to the control module.
Black 4-Pin Connector
Two-Way Transceiver/Antenna Module:
The two-way transceiver/antenna mounts on the windshield
(Inside). We suggest you mount it on the lower left or upper left
hand side of windshield (driver side). Warning! Do not mount in
such a manner that it obstructs the drivers view.
• Remove the protective tape backing.
• Carefully align the two-way transceiver/antenna and apply to windshield.
• Route the black connector wire behind the trim and connect to the two-way transceiver/antenna.
• Connect the other end to the control module.
• Special considerations must be made for windshield glass as some newer vehicles utilize a metallic
shielded window glass that will inhibit or restrict RF reception. In these vehicles, route the two way
transceiver/antenna module away from metallic shielded window glass as far away as possible.
Brown 3-Pin Connector
Optional Paging (Knock) Sensor:
The optional paging (knock) sensor can be added on.
1. Peel the protective paper from the double sided adhesive tape and attach one side to the bottom part of the
paging sensor.
2. After cleaning the area around left bottom part of the front window so that it stays attached firmly, the
paging sensor should be attached on the front window.
3. Hide the wire by carefully pushing it inside the space of the front window's mold trim.
4. Adjusting the sensitivity sensor, if you turn the adjustment screw clockwise, the sensitivity is increased,
counter clockwise sensitivity is decreased.
For best reception results, we suggest
mounting the antenna horizontally.
5
Advertisement
