Advertisement
Wiring
White 10-Pin Mini Connector
Pink Wire:
(-) 200mA Programmable Output (See Feature Programming Part 3)
Unlock the Driver's Door First Output (Factory Default Setting)
The 2 step unlock feature will work for the most fully electronic door lock circuit. The vehicle must have an
electronic door lock switch
(not the lock knob or key
switch), which locks and
unlocks all of the vehicle's
doors. When wired for this
feature, pressing the disarm
(or unlock) button one time
will disarm the alarm and
unlock the driver's door
only. Press disarm (or
unlock) button two times
within 3 seconds, the alarm
will disarm and all doors will
unlock.
Orange/White Wire:
This will become grounded when the alarm is disarmed. The current capacity of this wire is 200mA. It can be
connected to optional ignition disable relay - ECU disable relay fuel pump disable relay.
Orange Wire :
(-) 500mA
Grounded Output when Armed)
This
wire
will
grounded when the alarm is
armed. The current capacity of
this wire is 500mA. This
output can control a starter
disable relay, when the system
is triggered. The vehicle is
prevented
from
unauthorized starting. Also
becomes activated when the
engine is remote started.
12
(continued)
Orange/White
Wire
From Control Module
6-Pin Heavy Duty
White Connector
(-) 200mA Grounded Output when Disarmed - N.O. Disable
become
White 5-Pin
Mini Connector
Orange Wire
6-Pin Heavy Duty
any
White Connector
IN4003 Diode
87
87a
86
85
30
Yellow Wire
IN4003 Diode
87
87a
86
30
Violet Wire
"OFF"
"ON"
"ACC"
"START"
Cut
"OFF"
"ACC"
85
Starter
Cut
To
Ignition
Coil
"ON"
"START"
Advertisement
