Advertisement
Remote Start: Testing Your Installation
Method 2
Black/White Wire
Neutral Safety Switch
Black 9-Pin
Mini Connector
To connect to the key in sensor as shown in Method 2 follow these steps:
A. Locate the control wire that connects the driver's door pin switch to the key in sensor switch.
B. Cut this wire and connect the ignition cylinder side to chassis ground.
C. Locate the key in sensor switch wire that connects the chime module to the ignition cylinder.
D. Cut this wire and connect the ignition cylinder side to the Remote Start Negative Safety Shut down wire
WHITE/BLACK, using a 4003 series diode as shown above.
Note: A second 4003 series diode may be required to maintain the integrity of the hood open, shut down circuit. If this
is the case, it must be installed as shown in the diagram above. The anode (Non Stripped) side must be connect to the
WHITE/BLACK wire of the Remote Start Unit. The cathode (Striped) side must be connected to the hood pin switch.
AFTER THE CONNECTION OF THE NEUTRAL START SAFETY WIRE AS INDICATED IN ANY OF THE PREVIOUS
ALTERNATE CONFIGURATIONS, THIS CIRCUIT MUST BE TESTED FOR OPERATION. Retest by following the steps
outlined in NEUTRAL START SAFETY TEST shown in this manual.
To Hood Pin Switch
IN4003
Safety Shut Down
Ignition Key In Sensor Switch Closes
with Key In Ignition Cylinder
Safety
31
Advertisement
