Advertisement
Alarm Feature Programming (Part 3)
OFF
Turn the ignition switch from the OFF position to the
ON position 3 times leaving it in the OFF position the
third time.
Use the transmitter buttons as illustrated to adjust the features required. Keep re-pressing the transmitter button that
relates to the feature you want to adjust until the correct amount of chirps/beeps is heard. Move on to the next feature.
One Chirp
Button
LED One Pulse
(Factory Default Setting)
Pink Wire
Two Step Door
Unlock Output
White/Blue Wire
1 Pulse Activate
Brown/White Wire
(-) 200mA Horn Output
with Chirp Indicator On
Black/Green Wire
Channel 4 Output
+
Momentary Output
Five Chirps
LED Five Pulses
Black/Red Wire
+
Channel 5 Output
Momentary Output
Black/Violet Wire
+
Channel 6 Output
Momentary Output
Step 4
Step 1
Remote Feature Programming
Two Chirps
LED Two Pulses
Factory Security
Disarm Signal Output
White/Blue Wire
2 Pulse Activate
Brown/White Wire
Factory Security Rearm
Signal Output
Black/Green Wire Channel 4
Latched Output
Black/Green Wire: Ground Output During the Remote Start (Crank)
Black/Red Wire
Channel 5 Output
Latched Output
Black/Violet Wire
Channel 6 Output
Latched Output
Turn On the Ignition
3 long chirps & 3 flashes of the
parking lights will confirm exit of
ON
the programming mode.
ON
3X
Before 15 seconds has passed, push and release the
valet switch 5 times then push the valet switch a sixth
time and hold it down until 3 short chirp/beeps + 1
long chirp/beep is heard then release it. You are now in
Part 3 programming mode.
Step 3
LED Three Pulses
Pink Wire
Start Status Output
(Shock Sensor Bypass)
Brown/White Wire
(-) 200mA Horn Output
Black/Green Wire Channel 4
Output
Latched Output and Reset
with Ignition "ON"
Latched Output and Reset
with Ignition "ON"
Latched Output and Reset
Step 2
5X + 1X (Hold)
Three Chirps
Pink Wire
White/Blue Wire
3 Pulse Activate
for Trigger Only
Black/Green Wire Channel
Output
(Set to any intervals between 1
Black/Red Wire Channel 5
Black/Red Wire
Channel 5 Output
(Set to any intervals between
Black/Violet Wire
Channel 6 Output
(Set to any intervals between
with Ignition "ON"
Note: Waiting 15 seconds after the
last command will also cause the
system to automatically exit the
programming mode.
Four Chirps
LED Four Pulses
4 Output
Timer Programming
Sec. and 2 minutes)
Output
Timer Programming
1 Second and 2 minutes)
Black/Violet Wire
Channel 6 Output
Timer Programming
1 Second and 2 minutes)
19
Advertisement
