Figure 5-4 Remote Node Network Layer Options; Table 5-2 Tcp/Ip Remote Node Configuration - ZyXEL Communications Prestige 650R-31/33 User Manual

Prestige 650R-31/33 ADSL Router
IP Options:
The following table shows the fields in Menu 11.3 – Remote Node Network Layer Options.
FIELD
IP Address Press [SPACE BAR] and then [ENTER] to select Dynamic if the remote
Assignment node is using a dynamically assigned IP address or Static if it is using a
static (fixed) IP address. You will only be able to configure this in the
ISP node (the first node); all other nodes are set to Static.
Rem IP Addr This is the IP address of the remote gateway. Type the remote
Prestige's WAN IP address here (172.16.02 in the example Figure 5-3
shown previously). If the remote Prestige's WAN IP address is 0.0.0.0,
then type 192.168.1.1 (its LAN IP address) here.
Rem Subnet Type the subnet mask assigned to the remote node.
Mask
My WAN Addr Some implementations, especially UNIX derivatives, require separate
IP network numbers for the WAN and LAN links and each end to have a
unique address within the WAN network number. In that case, type the
IP address assigned to the WAN port of your Prestige.
NOTE: Refers to local Prestige address, not the remote router address.
NAT Press [SPACE BAR] and then [ENTER] to select Full Feature if you
have multiple public WAN IP addresses for your Prestige.
5-4
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment = Dynamic
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= N/A
NAT= Full Feature
Address Mapping Set= 1
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
IP Policies=
Enter here to CONFIRM or ESC to CANCEL:

Figure 5-4 Remote Node Network Layer Options

Table 5-2 TCP/IP Remote Node Configuration

Bridge Options:
Ethernet Addr Timeout(min)= N/A
DESCRIPTION
Remote Node TCP/IP Configuration
EXAMPLE
Dynamic
0.0.0.0
(default)
0.0.0.0
(default)
Full
Feature