Procedure To Configure Menu 1; Lan Setup; Figure 2-11 Menu 1 - General Setup; Table 2-4 General Setup Menu Fields - ZyXEL Communications Prestige 650R-31/33 User Manual

Prestige 650R-31/33 ADSL Router
The Domain Name entry is what is propagated to the DHCP clients on the LAN. If you leave this blank,
the domain name obtained by DHCP from the ISP is used. While you must enter the host name (System
Name) on each individual computer, the domain name can be assigned from the Prestige via DHCP.

2.11.1 Procedure To Configure Menu 1

Step 1. Enter 1 in the Main Menu to open Menu 1 – General Setup (shown next).
Step 2. Fill in the required fields. Refer to the table shown next for more information about these fields.
FIELD
System Name
Location (optional)
Contact Person's
Name (optional)
Route IP
Bridge

2.12 LAN Setup

This section describes how to configure the Ethernet using Menu 3 – LAN Setup. From the main menu,
enter 3 to display menu 3. Settings configured in Menu 3 – LAN Setup apply to the LAN side of the router
only.
2-14
Menu 1 - General Setup
System Name= ?
Location=
Contact Person's Name=
Route IP= Yes
Bridge= No
Press ENTER to Confirm or ESC to Cancel:
Figure 2-11 Menu 1 – General Setup

Table 2-4 General Setup Menu Fields

Choose a descriptive name for identification purposes. This name can
be up to 30 alphanumeric characters long. Spaces are not allowed, but
dashes "-" and underscores "_" are accepted.
Enter the geographic location (up to 31 characters) of your Prestige.
Enter the name (up to 30 characters) of the person in charge of this
Prestige.
Set this field to Yes to enable or No to disable IP routing. You must
enable IP routing for Internet access.
Turn on/off bridging for protocols not supported (for example, SNA) or
not turned on in the previous Route IP field. Select Yes to turn bridging
on; select No to turn bridging off.
DESCRIPTION
Hardware Installation and Initial Setup
EXAMPLE
Prestige
MyHouse
JohnDoe
Yes
No