Table of Contents
Advertisement
FIELD
ISP's Name
Encapsulation
Multiplexing
VPI #
VCI #
ATM QoS Type
Peak Cell Rate (PCR)
Sustain Cell Rate
(SCR)= 0
Maximum Burst Size
(MBS)= 0
My Login
My Password
ENET ENCAP
Gateway
Internet Access
Table 3-5 Internet Access Setup Menu Fields
Enter the name of your Internet Service Provider. This
information is for identification purposes only.
SPACE BAR
Press [
] to select the method of encapsulation
used by your ISP. Choices are PPPoE, PPPoA, RFC 1483 or
ENET ENCAP.
SPACE BAR
Press [
] to select the method of multiplexing
used by your ISP. Choices are VC-based or LLC-based.
Enter the Virtual Path Identifier (VPI) that the telephone
company gives you.
Enter the Virtual Channel Identifier (VCI) that the telephone
company gives you.
Press [SPACE BAR] and select CBR (Continuous Bit Rate) to
specify fixed (always-on) bandwidth. Select UBR (Unspecified
Bit Rate) for applications that are non-time sensitive, such as
e-mail. Select VBR (Variable Bit Rate) for bursty traffic and
bandwidth sharing with other applications.
This is the maximum rate at which the sender can send cells.
Type the PCR.
Sustained Cell Rate is the mean cell rate of a bursty, on-off
traffic source that can be sent at the peak rate, and a
parameter for burst-type traffic. Type the SCR; it must be less
than the PCR.
Refers to the maximum number of cells that can be sent at the
peak rate. Type the MBS. The MBS must be less than 65535.
Configure the My Login and My Password fields for PPPoA
and PPPoE encapsulation only. Enter the login name that your
ISP gives you. If you are using PPPoE encapsulation, then
this field must be of the form
identifies your PPPoE service name.
Enter the password associated with the login name above.
Enter the gateway IP address supplied by your ISP when you
are using ENET ENCAP encapsulation.
Prestige 650R-31/33 ADSL Router
DESCRIPTION
user@domain
where domain
EXAMPLE
MyISP
ENET ENCAP
LLC-based
8
35
UBR
0
0
0
N/A
N/A
N/A
3-15
Advertisement
Table of Contents
Troubleshooting
