Table of Contents
Advertisement
This chapter covers the parameters that are protocol-independent. Protocol-dependent
A remote node is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. When you use menu 4 to set up Internet
access, you are configuring one of the remote nodes.
4.1
Remote Node Setup
This section describes the protocol-independent parameters for a remote node.
4.1.1 Remote Node Profile
To configure a remote node, follow these steps:
Step 1.
From the main menu, enter 11 to display Menu 11 - Remote Node Setup.
Step 2.
When menu 11 appears, as shown in the following figure, type the number of the remote node
that you want to configure.
Remote Node Configuration
Remote Node Configuration
configuration (TCP/IP and Bridging) is covered in the following chapters.
Prestige 650R-31/33 ADSL Router
Chapter 4
4-1
Advertisement
Table of Contents
Troubleshooting
