Gui-Based Ftp Clients; Tftp And Ftp Over Wan Will Not Work When; Figure 11-2 Ftp Session Example; Table 11-2 General Commands For Gui-Based Ftp Clients - ZyXEL Communications Prestige 650R-31/33 User Manual

Prestige 650R-31/33 ADSL Router

11.2.4 GUI-based FTP Clients

The following table describes some of the commands that you may see in GUI-based FTP clients.

Table 11-2 General Commands for GUI-based FTP Clients

COMMAND
Host Address
Login Type
Transfer Type
Initial Remote Directory
Initial Local Directory

11.2.5 TFTP and FTP over WAN Will Not Work When

TFTP, FTP and Telnet over WAN will not work when:
1. You have disable Telnet service in menu 24.11.
2. You have applied a filter in menu 3.1 (LAN) or in menu 11.5 (WAN) to block Telnet service.
3. The IP address in the Secured Client IP field in menu 24.11 does not match the client IP. If it does not
match, the Prestige will disconnect the Telnet session immediately.
11-4
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit

Figure 11-2 FTP Session Example

Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied to the
server for anonymous access. Anonymous logins will work only if your
ISP or service administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary mode.
Specify the default remote directory (path).
Specify the default local directory (path).
DESCRIPTION
Firmware and Configuration File Maintenance