Rear Panel - Yamaha AW2816 Owner's Manual

Parts and their functions
1
N
U T
A
[PHANTOM +48V ON/OFF] switch
This switch supplies +48 V phantom power to the
INPUT (XLR) 1/2 jacks (2). Turn this switch ON
when condenser mics that require an external
power supply are connected to the INPUT 1/2
(XLR) jacks.
• This switch must be turned off if devices not requir-
ing an external power supply are connected to the
INPUT 1/2 (XLR) jacks.
• If the phantom power supply is turned on, power will
be supplied to both the INPUT (XLR) 1 and 2 jacks.
B
INPUT 1/2 (XLR) jacks
These are XLR-3-31 type input jacks for connect-
ing balanced condenser mics or line level devices.
The nominal input level is +4 dB to –46 dB. The
pin wiring is as follows.
Male XLR connector
C
INPUT 1/2 (TRS phone) jacks
These are balanced TRS phone input jacks.
Devices with unbalanced output, such as synthe-
sizers, can also be connected. The nominal input
level is –46 dB – +4 dB. The pin wiring is as fol-
lows.
1/4" TRS phone plug
22

Rear panel

M L K J
S R Q P O
1 (ground)
3 (cold)
2 (hot)
Tip (hot)
Ring (cold)
Sleeve (ground)
Operation section
5 4
9 8 7
• If plugs are inserted into both the XLR jack and TRS
phone jack of INPUT 1/2, the TRS phone jack will
take priority.
• Phantom power is not supplied from the INPUT 1/2
(TRS phone) jack.
D
INPUT 3–8 (TRS phone) jacks
These are balanced TRS phone input jacks. The
specifications of these jacks are the same as for the
INPUT 1/2 (phone) jacks.
E
INPUT 8 (Hi-Z) jack
This is a high-impedance unbalanced phone input
jack. Instruments with a high output impedance
such as passive-type electric guitars can be con-
nected directly to this jack. The nominal input
level is –46 dB to +4 dB.
If plugs are inserted into both the TRS phone jack and
the Hi-Z jack for INPUT 8, the Hi-Z jack will take pri-
ority.
F
OPTION I/O slot
An optional I/O card can be installed in this slot.
Tip!
For details on installing an I/O card, refer to page 10.
G
STEREO OUT jacks
These unbalanced RCA phono jacks are analog
outputs for the signal selected in the PATCH
screen Patch OUT page ( P.284). The nominal
output level is –10 dBV.
H
MONITOR OUT jacks
These balanced TRS phone jacks are analog out-
puts for monitoring the stereo bus, internal metro-
nome, solo signal, or direct output of recorder
tracks 1–16. The nominal output level is +4 dB.
3 2 1
6