Please Observe The Following Points; Turning The Power On; Setting The Internal Clock - Yamaha AW2816 Owner's Manual

Please observe the following points

This section explains how to turn the power of the AW2816 on and off, and how to set
the internal clock.

Turning the power on

When turning on the power of a system that includes
the AW2816, each device must be turned on in the
following order.
1 Any storage devices connected to the SCSI
connector of the AW2816, and external tone
generators connected to the input/output
jacks
B The AW2816 itself
C The monitor system connected to the output
jacks or the AW2816
Following the opening screen, the following screen
will appear in the display of the AW2816.
• If the AW2816 is powered-on when a SCSI-con-
nected external device is turned off, it may not start
up correctly.
• Do not turn off the power of a SCSI-connected
device while the AW2816 is in use.
• Before turning the power on, check that the power
cable plug is firmly connected to the AW2816 and to
the AC outlet. If the power is accidentally discon-
nected (turned off) while the AW2816 is in use, the
AW2816 itself and/or the hard disk may be damaged.
The first time the power is turned on after a new inter-
nal hard disk is installed in the AW2816, the display
will indicate "Format OK? [Y (Enter)/N (Any)]." If you
press the [ENTER] key at this time, the hard disk will
be formatted automatically, and the screen shown
above will appear when formatting has been com-
pleted.
Never turn off the power of the AW2816 while for-
matting is in progress. Doing so may damage the hard
disk itself.

Setting the internal clock

When the AW2816 is shipped from the factory, the
internal clock is set to Japan time. When you save a
song you created on the AW2816, the date and time
will be stored according to this internal clock.
Use the following procedure to set the date and time
of the internal clock after replacing the internal bat-
tery, or if you need to set the clock for any other rea-
son.
1
Press the [UTILITY] key
The following screen will appear.
2
Use the CURSOR [
sor (the blinking area in the display) to the
Y (year) field in the CLOCK area, and turn
the [DATA/JOG] dial to set the year.
The clock field will begin blinking.
3
In the same way, input the M (month), D
(date), h (hour), m (minute), and s (sec-
ond) fields.
The W (weekday) field will be set automatically
according to the date.
4
When you have input all of the values, use
the CURSOR keys to move the cursor to
the SET button, and press the [ENTER] key.
The CLOCK area will stop blinking, and the new
date and time will take effect. If you decide not
to change the date and time, move the cursor to
the RESET button and press the [ENTER] key.
Tip!
The internal clock continues to operate even when the
power of the AW2816 is turned off. Once you have
set the clock, you will not need to reset it unless you
change the battery.
Operation section
[F4] key.
] key to move the cur-
11