Yamaha AW2816 Owner's Manual page 292

VIEW screen
M
FADER
The current location of the fader is shown graphi-
cally and numerically. You can also edit the fader
value in this page.
N
ON/OFF
This indicates the on/off status of the channel. The
on/off status can also be switched in this page.
O
AUX
This area shows the send level of the signals sent
from this channel to AUX buses 1–6, both graphi-
cally and numerically. You can also edit the set-
tings in this page.
P
PRE/PST (Pre/Post)
This area shows whether pre-fader or post-fader
has been selected as the routing for the signal sent
from this channel to AUX buses 1–6. You can also
edit the settings in this page.
Q
AUX ON/OFF
This area shows the on/off status of the signals sent
from this channel to AUX buses 1–6. You can also
edit the settings in this page.
When a stereo output channel is selected, parameters
( 2 ), ( 5 ), ( 6 ), ( 8 ), ( 9 ), ( J ), and ( O ) will not be dis-
played. When a return channel is selected, parameters
( 4 ), ( 8 ), ( 9 ), and ( J ) will not be displayed.
290
Additional functions in the CH View
page
In the CH View page, holding down the [SHIFT] key
will assign the following additional functions to the
[F1]–[F5] keys.
• [F1] (EQ ON/OFF)
Switches the EQ on/off. This is the same function
as the button in the EQ area (3).
• [F2] (DYN ON/OFF)
Switches the dynamics processor on/off. This is the
same function as the button in the DYNAMICS
area (4).
• [F3] (ROUT OFF) key
Turns off all buttons 1–8 in the ROUT area (6).
(This does not affect the ST button.)
• [F4] (PAN CENTER) key
Sets the PAN/BALANCE knob (7) to the center
position.
• [F5] (EFF.INS ASGN) key
Accesses a popup window in which you can patch
an internal effect or input/output jack or input/out-
put channel to the insert send/return of the chan-
nel. This is the same function as the ASSIGN
button (L).
Reference section