Yamaha AW2816 Owner's Manual page 393

Can't save a file
• Is there sufficient space on the internal hard disk?
• Did you perform the correct shut-down procedure
when you last turned off the power? *
* If you turn off the power without performing the
shut-down, data may be lost or the hard disk may
be damaged.
Song file size is unnaturally large
• Even after you use recorder editing to erase a track
etc., that sound file will be saved on the disk as an
unused file. Execute the optimize operation in the
SONG screen Song Edit page.
File date is not recorded correctly
• Is the internal clock set to the correct date and time? *
* If the date and time of the internal clock has
drifted, the internal battery may have run down.
Please contact your Yamaha dealer.
A device connected to the SCSI connector is not
recognized
• The power of the SCSI device may have been turned
on after the AW2816.
• Is the SCSI cable connected correctly?
• The pins of the SCSI cable may have been bent.
• Is the ID of the SCSI device set correctly?
• Is termination specified correctly for the SCSI
device?
Can't save files on a SCSI device
• Is there sufficient free space on the save destination
media?
• Has the save destination media been formatted
appropriately?
Can't load files from a SCSI device
• Is there sufficient free space on the internal hard
disk?
CD-RW drive is not recognized
• Is the CD-RW drive connected correctly?
Can't create an audio CD
• Is CD-R media inserted?
• The inserted CD-R may have already been finalized.
• Is a signal recorded on the stereo track?
• The stereo track must be at least four seconds long.
• Have you saved a song in which a stereo track has
been recorded?
• It is not possible to create an audio CD from a song
whose Fs (sampling frequency) setting is 48 kHz.
• Does the display indicate DISK FULL?
• Create sufficient space on the hard disk.
• Erase unneeded tracks and then execute Optimize
to increase the available space.
An audio CD you created does not play back on a
conventional player
• An audio CD you created you not play back on a
conventional player unless the disc has been final-
ized.
Audio recorded on CD-RW media does not play
back on some players
• In order for audio data recorded on CD-RW media
to be played back, the player must support CD-RW.
Contact the manufacturer of the player regarding
CD-RW support.
The sound skips while playing an audio CD that
you created
• There may be differences in the quality of the com-
pleted CD depending on the type of CD-R media
you use. If this occurs, try using single speed (nor-
mal speed) recording rather than double-speed or
faster recording.
Can't use the [DATA/JOG] dial to control on-
screen parameters
• The [NUM LOCATE] key may be on.
• The [JOG ON] key may be on.
The display indicates MEMORY FULL or DISK
FULL, and recording or editing is not possible
• Erase unneeded tracks and then execute Optimize
to increase the available space.
The display indicates DISK BUSY during playback
• It is possible that the reading speed of the internal
hard disk is not fast enough, or that the reading
speed has slowed down because the recorded data
has become fragmented. Try deleting small regions
and re-recording. Alternatively, backup the data,
and try using one of the recommended hard disks.
Appendix
391