Yamaha AW2816 Owner's Manual page 316

REMOTE screen
Remote A–Remote D pages
Remotely control external MIDI devices
Function
Operate faders 1–8 and [ON] keys 1–8
to transmit specified MIDI messages for
controlling external MIDI devices.
Key operation
• [REMOTE] key [F1] (Remote A)–
[F4] (Remote D) keys
• Repeatedly press the [REMOTE] key
until the screen shown at the right
appears.
Screen functions
A
MIDI messages
This area displays (in hexadecimal) the MIDI mes-
sages assigned to the fader and [ON] key of the
channel selected by its [SEL] key.
Move the cursor to each numerical box, and turn
the [DATA/JOG] dial to edit the value of each byte
(as a two-digit hexadecimal number). The follow-
ing settings can be selected.
• 00–FF (hexadecimal)
Corresponds to the actual
MIDI message that will be
transmitted.
• END .................... Indicates the end of the MIDI
message. When you operate
the [ON] key or fader, the
MIDI message from the
beginning to immediately
before the END will be trans-
mitted.
• SW ([ON] switch only)
Indicates the on/off status of
the [ON] key. The byte that
you set to "SW" will be trans-
mitted as a value of 7F (hexa-
decimal) when the [ON] key
changes to "on," and as a
value of 00 (hexadecimal)
when it changes to "off."
314
1
• FAD (fader only).. Indicates the current position
Tip!
The MIDI message that can be assigned to one fader or
[ON] key is a maximum of 16 bytes including "END."
• When assigning a MIDI message, you must be sure to
add "END" at the end of the message. If "END" is
not specified, the MIDI message will not be sent.
• When assigning a MIDI message to a fader, you must
set one of the bytes to "FAD." If "FAD" is not speci-
fied, the MIDI message will not be sent when you
operate the fader.
• When assigning a MIDI message to an [ON] key, you
may set one of the bytes to "SW" as desired. In this
case, the MIDI message will be transmitted as SW=7F
when the [ON] key is turned on, and as SW=00 when
the [ON] key is turned off.
• If you do not specify "SW," the MIDI message you
input in this page will be transmitted only when the
[ON] key is turned on.
• If you assign a MIDI message manually, it is possible
that an illegal MIDI message may be transmitted. As
far as possible, we recommend that you assign MIDI
messages by using the LEARN button ( 4 ). (For
details on using the LEARN button, refer to
page 208.)
Reference section
2 3 4
of the fader. The byte that you
set to "FAD" will be transmit-
ted as a value 00–7F (hexa-
decimal) when you operate
the fader.
5
6