Advertisement
CONNECTIONS (REAR PANEL)
m
"QO0
0?
il
1
i/Mjġno
SPEAKER
Lomo)
LINE INPU aa
@
Speaker ON/OFF switch
This switch turns the sound from the PF1500's speakers on
and off.
O OUTPUT terminals (I and ll)
These jack terminals can be used to connect the PF1500 to
an external amplifier, mixer, etc. A stereo signal is output
when the reverb is used.
©
LINE INPUT terminals (I/MONO and ll)
These jack terminals can be used to connect other equip-
ment (eg RX rhythm programmer, TQS tone generator) to be
played through the PF1500's amplifier and speakers.
DO
NOT use these sockets to connect speaker-level signals.
Damage will occur to the PF1500, and possibly to the other
equipment.
(4) SUSTAIN and SOFT
pedal connections
Use these sockets to connect the PF1500 stand pedals, as
described in the section SETTING UP.
* Effects can also be turned on and off using the optional
foot pedals FC4, FCS, or FC8. (The half-pedal effect is not
accessible with the FC8.)
MIDI THRU, OUT and IN terminals
MIDI (Musical Instrument Digital Interface) allows the
PF1500 to transmit and receive musical commands to and
from other MIDI-equipped devices. The IN terminal should
be used if the PF1500 is to be controlled by a sequencer (eg
TQ5) or another keyboard, and the OUT terminal for when
the PF1500 is to control another device (eg the tone genera-
tors of the TOS).
The THRU
terminal echoes the data
received at the IN terminal, and is used when "daisy-
chaining" MIDI devices. See the sectionon MIDI OPERA-
TION
for full details.
'2
Advertisement
