Yamaha AW2816 Owner's Manual page 213

5
Transmit a control change #10 MIDI mes-
sage from your external device.
The captured control change data will be input
in the MIDI message display area. If a control
change is received, the byte corresponding to the
changing value 0–127 (the third byte) will auto-
matically be set to "FAD."
Tip!
When a MIDI message is received while the LEARN
button is on, the byte following the last byte of the
message will automatically be input as "END."
• If a MIDI message longer than 16 bytes is received
when the LEARN button is on, the first 16 bytes will
be input. In this case, the "END" value will not be
input, meaning that no MIDI message will be trans-
mitted when you operate the fader.
• If the MIDI message assigned to the fader does not
contain a "FAD" byte, no MIDI message will be
transmitted when you operate the fader.
6
Make sure that a control change has been
input in the MIDI message area. Then
move the cursor to the LEARN button and
press the [ENTER] key to turn off the
LEARN button.
7
Move the cursor to the REMOTE A area in
the right of the display, and press the
[ENTER] key to switch the button to
"ENABLE."
The remote functions of the Remote A page will
be enabled, and MIDI messages will be transmit-
ted when you operate faders 1–8/[ON] keys 1–8.
8
Operate fader 1.
As you raise or lower fader 1, control change #10
messages will be transmitted from the MIDI OUT
connector with a value that varies in the range of
0–127.
Tip!
If you used the LEARN button to capture a channel
message, the MIDI reception channel will also be
used as the MIDI transmission channel.
9
If you want to name the fader to which the
MIDI message was assigned, move the cur-
sor to the NAME EDIT button in the lower
part of display, and press the [ENTER] key.
The NAME EDIT popup window will appear.
10
Use the character palette to input a name,
move the cursor to the OK button, and
press the [ENTER] key.
For details on inputting characters, refer to
page 37.
The name you input will be shown below the 1–
8 buttons in the lower part of the display.
Tip!
• The edited contents of the Remote A–Remote D
pages are saved as part of the song.
• If you want to return the settings of the currently
selected page (Remote A–Remote D) to the factory
default settings, hold down the [SHIFT] key and
press the [F5] key.
Operation section
13
209