Table of Contents
Advertisement
7. INITIAL SETTINGS
3. Rotate the Course control knob to select [ON] then push the knob to activate the
power assist.
When this is done, the menu items for power assist appear.
4. Rotate the Course control knob to select the current setting value for [For
Speeds Under] then push the knob.
5. Rotate the Course control knob to set the highest speed at which power assist
activates (setting range: 1.0-25.0 kn).
Note: When the power assist activates at high speed, the vessel may turn faster
than intended. Set [For Speeds Under] according to the vessel and rudder feature.
6. Rotate the Course control knob to select the current setting for [Power Assist ST-
BY] then push the knob.
7. If you want power assist in the STBY mode, select [ON] then push the Course
control knob. If not, select [OFF].
8. Rotate the Course control knob to select [Power Assist Rudder Speed] then
push the knob.
Power Assist Rudder Speed
Rudder Speed:
Turn helm to PORT/STBD to set
rudder speed.
Higher value = Faster speed
9. The cursor is selecting the current setting value for [Rudder Speed]; push the
Course control knob.
10. Rotate the Course control knob to select a value then push the knob (setting
range: 1-10).
The higher the setting, the stronger the power assist.
11. Press the
7-18
Safe Helm/P.Assist Setup
Safe Helm: ON Return Delay 5 sec
Safe Helm Response
Safe Helm Beep: ON
Power Assist:
ON
For Speeds Under 10.0kn
Power Assist STBY: OFF
Power Assist Rudder Speed
10
Push MENU key to return
key to close the [Safe Helm/P.Assist] menu.
Not shown with Fantum Feedback
TM
.
Advertisement
Table of Contents
