Table of Contents
Advertisement
5. MAINTENANCE, TROUBLESHOOTING
Error
Error message
no.
1305
No speed data. Please check speed
source or enter manual speed value
in Parameter Setup.
1307
No wind data
1309
Wind data is shifted.
1311
No NAV data. Wait for 1 seconds.
1315
Degradation of NAV data quality.
1317
No position data
1801
EVC Interface error
1803
No contact with EVC.
1901
Rate sensor error
1903
Backup error
1905
Initializing heading sensor. This takes
two minutes, please wait.
Fail
0001
Drive unit error. Please turn OFF and
check drive circuit.
0003
Drive unit overloaded. Please turn
OFF and check drive circuit.
0005
Drive unit is overheated. Please turn
OFF and check drive circuit.
0007
Bypass/clutch drive error. Please turn
OFF and check drive circuit.
0009
Bypass/clutch is overloaded. Please
turn OFF and check drive circuit.
0011
Bypass/clutch is shorted out. Please
turn OFF and check drive circuit.
0013
Rudder drive error
0017
Rudder angle error
0019
EVC interface fail.
0301
Communication error
Notice
2001
Input voltage is under limit
2003
Input voltage is over limit
2101
NAV mode parameter error
2105
Start to turn by fishing mode
2107
Circle mode stopped
2109
Mode was changed.
5-14
Meaning, remedy
Check the speed source or enter the speed manu-
ally.
Check wind sensor.
Wind data has changed abruptly. Check wind sen-
sor.
Check nav data sensor.
Check nav data sensor.
Check position-fixing equipment.
Communication error between the processor unit
and IPS interface unit or NMEA data converter.
Check the connection with IPS interface unit or
NMEA data converter.
Communication error with the EVC system. Check
the connection with the EVC system
Check rate sensor.
All user and engineer default settings are restored.
Reenter installation settings.
The heading sensor is initializing. Wait approx. two
minutes until the heading sensor completes initial-
izing.
Turn off power
Turn off power.
Temperature of drive circuit is higher than 80°C
(176°F). Turn off power.
Bypass/clutch error. Turn off power.
Bypass/clutch overload. Turn off power.
Bypass/clutch is shorted. Turn off power.
Turn off power.
Turn off power.
System error of the IPS interface unit or NMEA data
converter. Turn off power, and then check the con-
dition of the IPS interface unit or NMEA data con-
verter.
No communication between processor unit and all
control units. Turn off power.
Input voltage under limit. Check power supply.
Input voltage over limit. Check power supply.
Invalid parameter entered in NAV mode. Reenter
parameter.
Boat is starting to turn after dodge operation.
Circle mode was stopped.
Steering mode changed.
Advertisement
Table of Contents
