How To Select The Display Data - Furuno NAVpilot 711C Operator's Manual

1. OPERATIONAL OVERVIEW
1.5.3

How to select the display data

You can select the display data to show in the STBY, AUTO, NAV, and WIND modes.
1. Long press the
2. Rotate the Course control knob to select [Other Menu] then push the knob.
3. Rotate the Course control knob to select [System Setup] then push the knob.
4. Rotate the Course control knob to select [Display Data Select Menu] then push
the knob.
The window as shown below appears.
5. Rotate the Course control knob to select the steering mode desired then push
the knob.
6. Rotate the Course control knob to select the current setting for display division
desired then push the knob.
Note: Page layout of the page 3 depends on setting of [Data Box Format].
7. Rotate the Course control knob to select display data desired then push the
knob.
The table below shows all the display data available.
Page/Data
Graphic / numerical data
Page 1: [Data 1]
Page 2: [Data 1]
Page 3: [Data 1]
Analog indicator
Page 1: [Data 2]
Page 2: [Data 2]
1-8
key to open the menu.
Display Data Select Menu
STBY
AUTO
NAV
WIND*
Data 1
Data 2 Data 2
Page 1
Data Displayed
[Normal]
[Compass]
[Highway]
[Wind Apparent]
[Wind True]
1
[Rudder]*
[Engine Speed]
1
[Rudder]*
[Deviation]
[Steering Direc-
2
tion]*
*: Sailboats only
Data 1
Data 3 Data 2
Page 2
Data meaning
Numerical display (see section 1.5.2)
Compass rose
Graphic presentation of progress to-
wards waypoint
Analog and digital apparent wind direc-
tion speed
Analog and digital true wind direction
speed
Analog and digital rudder angle
Analog engine speed (revolution meter)
Rudder angle
Heading deviation
For WIND mode, wind deviation
Steering direction
Data 1
Data 3
Page 3