Table of Contents
Advertisement
7. INITIAL SETTINGS
Air bleeding
Air bleeding can not be performed if the drive unit has not been selected.
1. Select the option for [Air Bleeding] from the [Dockside Setup] menu then push the
Course control knob.
2. Rotate the Course control knob to select [Yes] then push the knob.
The message shown below appears.
3. Press the
4. Remove the appropriate rudder cap of the cylinder to bleed air, then reattach the
cap.
5. Press the
6. Remove the appropriate rudder cap of the cylinder to bleed air, then reattach the
cap.
7. Repeat steps step 3-6 to bleed air completely.
8. Press the
Rudder test
The rudder test can not be performed if the drive unit has not been selected.
1. Select the option for [Rudder Test] from the [Dockside Setup] menu then push the
Course control knob.
2. Rotate the Course control knob to select [Yes] then push the knob.
The message shown below appears.
3. Center the rudder then push the Course control knob.
The message shown below appears.
4. Press the
5. Release the
The message shown below appears.
7-12
Push arrow key to enable
pumpset
Push MENU key when done
key.
key.
key to finish air bleeding.
Use wheel to
center rudder before
rudder test.
Are you sure?
Yes
Push and hold STBD arrow
key until rudder moves.
Move Rudder
Abort
key and confirm the direction of rudder movement.
key.
Which side did rudder
move to?
STBD side
PORT side
Not Move/Abort
No
Advertisement
Table of Contents
