Control Unit Test; Evc Interface Test - Furuno NAVpilot 711C Operator's Manual

5. MAINTENANCE, TROUBLESHOOTING
5.3.3

Control unit test

This test checks the control unit for correct operation. Open the diagnostic test options
window, select [Control Unit] then push the Course control knob.
ROM: OK 6454011-**.**
RAM: OK Backup: OK
Communication: OK
Controller ID: 2
CAN ID: 0
To close the test result, press the
Test result items of the control unit test
• [ROM]: ROM test result ("OK" or "NG"), program number
• [RAM]: RAM test result ("OK" or "NG")
• [Backup]: Backup data test result ("OK" or "NG")
• [Communication]: Communication state between the processor unit and control unit
("OK" or "NG")
• [Controller ID]: ID of the control unit
• [CAN ID]: ID of CAN bus equipment
• [CPU]: CPU board version number
5.3.4

EVC interface test

This test confirms the program version no. of the IPS interface unit (IF-700IPS) or
NMEA data converter (IF-NMEA2K2).
Open the diagnostic test options window, select [Processor Unit] then push the
Course control knob. This test is available when [Boat Type] is set to [EVCS Boat].
EVC Interface
ROM: OK 6454018*-**.**
6454019*-**.**
RAM: OK
To close the test result, press the
Test result items of the EVC interface test
• [ROM]: ROM test result ("OK" or "NG"), program number
• [RAM]: RAM test result ("OK" or "NG")
5-4
Control Unit
6454010-**.**
CPU:*
*: Program no. for IF-700IPS. In case of IF-NMEA2K2,
the following program no. appears.
1451436-**.**
1451437-**.**
**.**: Program version no.
*: Version no.
**.**: Program version no.
key.
key.