Master F-13 User Manual page 62

Lubricating
The running belt must be lubricated with specially configured methyl silicone
oil after used for a period of time.
1. Advice:
When use time a week is less than 3 hours, it should be lubricated once in five
months.
When use time a week is between 4-7 hours, it should be lubricated once in two
months.
When use time a week is more than 7 hours, it should be lubricated once in one
month.
It can't be over-lubricated. It is not the more lubricant, the better. Remember:
proper lubricating is the important factor to increase the treadmill's service time.
2. Lubricating methods
A.Traditional method
For the methods to examine whether it is needed lubricant, you only need catch
up the running belt and touch the central part of the back of the belt with hand
as nearly as possibly. If the belt is with silicon resin (a bit sense of dampness)
inside, this means no lubricant is needed; if the running board is dry and you
feel no silicon resin inside, this means lubricant is needed.
A. Steps for coating the running board with lubricant: (see the picture)
B. Stop the rotation of the running belt and fold the machine.
C. Pick up the belt of the back of the body frame: stretch the oil holder as
nearly as possible into the moving place of the belt, coat the inner side of the
belt with silicone oil and coat both sides of the belt with silicone resin, and then
operate the treadmill at the speed of 1K M/H so as to evenly coat the silicone
resin; and step on the belt from left to right for a few minutes, then the silicone
resin will be completely absorbed by the belt.
SIX Product Maintenance
62