Rear Panel (Connecting The External Equipment) - Roland Fantom-06 Reference Manual

Rear Panel
(Connecting the External Equipment)
* To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections.
C USB
Computer
USB flash drive
PEDAL
A
Pedal unit
(RPU-3)
PEDAL jack
A
Controller Explanation
If you connect a pedal switch (DP series, sold
HOLD jack separately) to this jack, you can use it as a
damper pedal.
CTRL2 jack You can also assign various functions to the
pedals that are connected to the CTRL 1 and
CTRL1 jack
CTRL 2 jacks.
* Use only the specified expression pedal. By connecting any other
expression pedals, you risk causing malfunction and/or damage
to the unit.
B MIDI connectors
Controller Explanation
MIDI OUT connector Transmit or receive MIDI messages to or from
MIDI IN connector an external MIDI device connected here.
USB port
C
Controller Explanation
USB EXT DEVICE jack Connect this to an external USB device.
Connect this to your computer to transfer
USB COMPUTER port
performance data and audio signals.
Use a commercially available USB flash drive.
However, we cannot guarantee that all
USB MEMORY port
commercially available USB flash drives will
work.
MIC/LINE INPUT jacks
D
Controller Explanation
Adjusts the input level of
LEVEL knob
the MIC jack.
D MIC/LINE INPUT
Dynamic Audio
Microphone equipment
B
Expression pedal (EV-5)
or
Pedal switch (DP Series)
MAX
SUB OUT
E
Monitor speaker
(built-in amplifier)
AC Adaptor
Ù to Power outlet
Controller
MIC jack
R, L/MONO jacks
SUB OUT jack
E
Controller
R, L/MONO jacks
STEREO (PHONES)
jack
MAIN OUT jack
F
Controller
R, L/MONO jacks
(Balanced)
PHONES jack
G
A set of headphones can be connected to this jack.
Even if headphones are connected, an audio signal is sent
from the OUTPUT jacks.
Ground terminal
H
Connect this to an external earth or ground if necessary.
MIN
Panel Descriptions
G PHONES jack
MAIN OUT
F
Mixer Headphones
I
H
(included)
AC Adaptor
Explanation
Connect your microphone here.
Connect your audio device, external
synthesizer or other equipment to these jacks.
Explanation
These are output jacks for sub-out audio.
The SUB OUT audio signal is output in stereo.
You can also connect a pair of headphones
here with a stereo mini plug. When doing so,
set the volume from the MIXER screen, and
the source you want to hear from the OUTPUT
screen.
Explanation
These are balanced output jacks for audio
signals. Connect them to your mixer.
* Pin assignment of MAIN OUT jack
TIP: HOT
RING: COLD
SLEEVE: GND
J K
2: HOT 1: GND
3: COLD
11 11