Connecting The Vr-760 To External Equipment - Roland V-Combo VR-760 Owner's Manual

Connecting the VR-760 to External
Equipment
The VR-760 is not equipped with an amplifier or speakers. In order to hear
the sound, you will need to connect audio equipment such as a monitor
speaker system or stereo set, or use headphones.
Audio cables, MIDI cables, and headphones are not included. Consult your
Roland dealer if you need to purchase accessories such as these.
fig.01-02(Connecting)
MIDI sound module etc.
1.
Before you begin making connections, confirm the
following.
Is the volume level of the VR-760 or connected amp turned all the way
down?
Is the power to the VR-760 or connected amp turned off?
2.
Connect the VR-760 and the external device.
Use audio cables to connect audio equipment, such as an amp or speakers.
Use MIDI cables to connect MIDI devices.
If you are using headphones, plug them into the PHONES jack.
* This instrument is equipped with balanced (XLR) type
input jacks. Wiring diagrams for these jacks are shown
below. Make connections after first checking the wiring
diagrams of other equipment you intend to connect.
MIDI IN
MIDI OUT
Monitor speakers
MIDI sequencer etc.
Before You Begin Playing
(powered)
Mixer
Powered Amplifier
NOTE
To prevent malfunction
and/or damage to speakers
or other devices, always
turn down the volume, and
turn off the power on all
devices before making any
connections.
Stereo
headphones
NOTE
Use Stereo headphones.
17