Rear Panel (Connecting The External Equipment) - Roland FANTOM-06 Owner's Manual

Panel Descriptions
Rear Panel
(Connecting the External Equipment)
* To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections.
C USB
Computer
USB flash drive
A PEDAL
Pedal unit
(RPU-3)
PEDAL jacks
A
Controller Explanation
If you connect a pedal switch (DP series, sold
HOLD jack separately) to this jack, you can use it as a
damper pedal.
You can also assign various functions to the
CTRL2 jack
pedals that are connected to the CTRL 1 and
CTRL1 jack
CTRL 2 jacks.
* Use only the specified expression pedal. By connecting any other
expression pedals, you risk causing malfunction and/or damage
to the unit.
MIDI connectors
B
Controller Explanation
MIDI OUT connector Transmit or receive MIDI messages to or from
MIDI IN connector an external MIDI device connected here.
USB port
C
Controller Explanation
USB EXT DEVICE jack Connect this to an external USB device.
Connect this to your computer to transfer
USB COMPUTER port
performance data and audio signals.
Use a commercially available USB flash drive.
However, we cannot guarantee that all
USB MEMORY port
commercially available USB flash drives will
work.
10
D MIC/LINE INPUT
Dynamic Audio
Microphone equipment
B
Expression pedal (EV-5)
or
Pedal switch (DP series)
SUB OUT MAIN OUT
E F
Monitor speaker
Mixer
(built-in amplifier)
AC adaptor
(included)
to AC outlet
MIC/LINE INPUT jacks
D
Controller Explanation
Adjusts the input level of
LEVEL knob
the MIC INPUT jack.
MIC jack
Connect your microphone here.
Connect your audio device, external
R, L/MONO jacks
synthesizer or other equipment to these jacks.
E SUB OUT jacks
Controller Explanation
R, L/MONO jacks These are output jacks for sub-out audio.
The SUB OUT audio signal is output in stereo.
You can also connect a pair of headphones
here with a stereo mini plug. When doing so,
STEREO (PHONES) jack
set the volume from the MIXER screen, and
the source you want to hear from the OUTPUT
screen.
F MAIN OUT jacks
Controller Explanation
These are balanced output jacks for audio
signals. Connect them to your mixer.
* Pin assignment of MAIN OUT jack
R, L/MONO jacks
(Balanced)
G PHONES jack
Headphones
J K
I
H
AC Adaptor
* Use the cord hook to secure
the cord of the AC adaptor as
shown in the illustration.
MIN
MAX
TIP: HOT
2: HOT
RING: COLD
SLEEVE: GND
3: COLD
1: GND