Making Loop Settings (Loop) - Roland Fantom-06 Reference Manual

Playing the Sequencer
Selecting tones with the category buttons
Press a tone category button [1]–[16] on the PATTERN screen or
other screens to select the tone.
1 .
Accesses the PATTERN screen.
2 .
Select the current zone.
3 .
Press a tone category button [1]–[16].
The tone corresponding to the category of the button you
pressed is selected.
MEMO
Pressing the same tone category button twice displays the TONE
LIST screen. Press the same tone category button again to switch
between category tabs within the same category group.
NOTE
This function cannot be used on some screens like the TR-REC
screen.
Making Loop Settings
(LOOP)
For each pattern, you can make detailed settings to specify whether
and how it loops.
MEMO
The loop parameter settings of each pattern are saved in the scene.
1 .
On the PATTERN screen, select the pattern box
whose settings you want to edit.
The selected pattern box has a red border. To select a
pattern, you can use the cursor [ à ] [ á ] [ ã ] [ â ] buttons, or
directly long-touch the pattern box to put it in play-standby
mode.
The selected pattern box
2 .
Select [E1] LOOP SETTING.
The LOOP SETTING screen appears.
Pattern data area
Loop region
¹ Ranges that are shown in brighter colors in the pattern data
area indicate loop ranges.
¹ In the pattern data area, the presence or absence of note
data is shown as a simple piano-roll display.
3 .
Edit the loop parameters.
112 112
Measure number
Parameter Value
[E1] LOOP SW OFF, ON
Start [E3] 01-01-000–
knob 64-01-000
Length [E4]
1–64
knob
SYSTEM
MEASURE
[E6] Change
Timing
PTN END
4 .
When you have finished editing, press the [EXIT]
button to return to the PATTERN screen.
Explanation
Turns looping on/off. A pattern
for which this is "OFF" will play
once during playback, and then
automatically stop (one-shot
playback).
Specifies the play start point. You
can set this value in units of a beat.
The loop region starts at the point
specified by Start and extends for
the length specified by Length.
Specifies the length of the loop.
You can specify a value that is
longer than the length of the
original pattern. The added
portion will be blank playback.
Follows the "Pattern Change
Timing" setting in system settings.
The pattern changes at the
beginning of the next measure.
The pattern changes at pattern
end (the last measure played by
the pattern, including the loop
range).